Maya: Official Concept:Picture frame & Nail







I can't seem to make the curve tool into a "solid object" I tried going into surfaces and extruding but I could't figure it out, I think I might actually draw the line in, as part of a piece of my Matt painting..
at Monday, January 03, 2011

1 comment:

  1. Ruben Martins3 January 2011 at 10:45

    hi, good to see your getting into maya, to easily create a piece of string just get a polygon cylinder where you will place on 1 side of the curve. then turn on the face select the faces which are facing the opposite side of the curve and then also select the curve, and then just extrude, at first will look weird then open the extrude node and add divisons- usually 15 to 20- and it is done. hope it helps !!

    ReplyDelete

Important Criticism

Subscribe to: Post Comments (Atom)